GoFlex Net - Trouble activating?

GoFlex Net - Trouble activating?



If you are having trouble activating your GoFlex Net, this article should help you diagnose the issue.

If you are having trouble activating your GoFlex Net, this article should help you diagnose the issue without immediately needing to contact Seagate Support.  Start by checking the status of the LED light on the front of the unit.

Status LED Blink Codes
The light on the front of the network adapter provides information about its current state and can help determine what steps to take in activating your device.

LED State Interpretation

Green blinking

The GoFlex Net is booting up.

Green solid

The GoFlex Net is on and correctly connected to the service.

Yellow/amber solid

The GoFlex Net has booted up properly but failed to connect to the service.

Yellow/amber blinking

The GoFlex Net failed to boot up normally.

Now, we will examine these LED States in more detail.

Blinking yellow (amber) LED:
This issue most commonly suggests a hardware failure, but there are 3 steps that you can try if your GoFlex Net’s LED is steadily blinking yellow/amber.

  • Power down the unit, wait 20 seconds, then power the unit back on.
  • Disconnect and reconnect all the cables.
  • Try a different Ethernet cable.

If these 3 actions do not succeed in correcting steadily blinking yellow/amber LED state, you will need to replace the device.

Solid yellow (amber) LED:
A solid amber light means the GoFlex Net is not communicating with the Pogoplug service.  
First, verify your Internet connection is working properly.  If you can access the Internet from a computer on your network, try the following troubleshooting procedures:

  • DHCP - Ensure DHCP is enabled on your router.  This is usually a basic setting offered in your router setting page.
  • Static DNS - Does your network require you to setup 'static DNS' for each device on your network?  If so, please setup 'static DNS' on your router.
  • UDP - Ensure UDP traffic is unfiltered, both into and out of your network. If UDP traffic is blocked or filtered, the GoFlex Net will not properly communicate with the Pogoplug service.

For more information about network configuration, please contact Seagate Support or contact your router manufacturer.

Solid green LED:
A solid green LED coupled with the inability to complete activation could be due to two problems:

  • Error message - "This device is already been registered."
  • Not receiving a confirmation email. Make sure to check your email spam filter!

If you receive this error message or do not receive your confirmation email, send an email to support@pogoplug.com and include:

  • The 26-character Device ID
  • The Email Address you used to activate your service




Subscribe

Language


Was this article helpful?


We appreciate any feedback.



Loading...