GoFlex TV - Cables and Connections

GoFlex TV - Cables and Connections


Instructions, precautions, and troubleshooting for GoFlex TV cabling and connections.

Cable Connection Rules

  • The GoFlex TV and all TV/stereo components should be powered down when connecting cables.
  • Do not connect both composite and component video cables at the same time.
  • Composite (yellow, red, white RCA) only support up to 480i.
  • Component red green blue supports all modes, (720i, 720p, 1080i), no audio. On the GoFlex TV, the component cable is a three-in-one; the connector on the GoFlex TV unit is one single plug.
  • Do not use yellow, white, red, AV cable to connect to green, red, blue, (HD video) connections.
  • HDMI cable is required for 1080p. An HDMI cable does not ship with the GoFlex TV. Seagate recommends using certified 1.3 HDMI cables.

Symptoms of incorrect cabling

  • No picture, no audio, distorted screen, or color is off.
  • If colors are mismatched on your component/composite cable, your television screen may be black, or you may see strange color effects on the entire screen.
  • If the resolution is set to 'high' on your television, it may not display at all or it may show a distorted picture.

Troubleshooting Cable Connections

  • Ensure the colors of the component and composite cables are matching the right ports on the television.
  • If you are running your cables through a surround receiver, eliminate the receiver and connect directly to the TV with the audio and video cables.
  • If you are running your cables straight to the television, try the GoFlex TV on another television.
  • If you are using HDMI, ensure you have a certified 1.3 HDMI cable.
  • Ensure the GoFlex TV has the latest firmware.
  • Press the reset button on the back of the GoFlex TV to switch between NTSC 480i and PAL 576i. (Pressing reset always defaults to the lowest SD interlace resolution.)

Check Your TV Settings

  • In most cases, newer televisions automatically detect devices that are connected to their inputs, so there is no need to adjust your TV’s input settings. However, you will need to verify the settings when problems occur. Make sure the TV is set to the proper input channel, component, composite, etc.
  • If no picture, try resetting the resolution to SD interlace on the input where the theater is connected to the back of the TV. 
  • For troubleshooting, try using the same cables and input channel of a working device such as a DVD player.
  • If connected to a surround receiver and then to a TV, they must both be on the correct input channels. When troubleshooting picture issues, eliminate the receiver and connect directly to the TV.
  • Some TV’s may share component and HDMI input and output lines.
    If input 1 on your TV has an component and HDMI assignment, any devices connected to the HDMI port may override any component signals on input, so you need to separate your HDMI and component inputs. Move your component cables to input 2 on the TV. This same circumstance also applies to home theater systems that are being run through a surround receiver.  




Subscribe

Language


Did this article answer your question?


How could we make this article more helpful?